The core is a UDP/IP hardware protocol stack. Designed for standalone operation, the core offloads the host processor from the task of UDP/IP encapsulation and enables media streaming with speeds up to 40Gbps even in processor-less designs.
Trouble-free operation is ensured through run-time programmability of all the required network parameters (local, destination and gateway IP addresses; UDP ports; and MAC address). The core implements the ARP Protocol, which is critical for multiple access networks, and the Echo Request and Reply Messages of the ICMP widely used to test network connectivity. It can use a static IP address or automatically request and acquire an IP address from a DHCP server. Finally, the core supports 801.1Q tagging, and is suitable for operation in a Virtual LAN.
The core is easy to integrate in systems with or without a host processor. Packet data can be read/written to the core via dedicated streaming-capable interfaces, or via registers mapped on an SoC bus.
Protocols, IPv4 without packet fragmentation, Jumbo and Super Jumbo Frames, ARP with Cache, ICMP (Ping), IGMP v3 (Multicast), UDP/IP Unicast and Multi
Up to four UDP channels
Run time programmable network parameters: Local, Destination and Gateway IP address, Source and Destination UDP ports, MAC address
Available pre-integrated with the Intel FPGA 40G Ethernet MAC core
Device Utilization and Performance
The silicon resources requirements depend on the core configuration. A quad channel core synthesizes to approximately 7,500 ALMs and requires 400k bits of memory, while a single channel core synthesizes to approximately 97,000 ALMs and requires 800k bits of memory.
To deliver a 40Gbps under the worst case scenario, the core needs to be clocked at 312.5MHz, however running the core at 200MHz should suffice to deliver 40Gbps in realistic UDP/IP traffic scenarios.
Contact CAST at firstname.lastname@example.org to arrange for a core evaluation
IP Quality Metrics
Year IP was first released
Latest version of Quartus supported
Altera Customer Use
IP has been successfully implemented in production with at least one customer
Customer deliverables include the following:
Design file (encrypted source code or post-synthesis netlist)
Simulation model for ModelSim Altera edition
Timing and/or layout constraints
Testbench or design example
Documentation with revision control
Any additional customer deliverables provided with IP
Wrapper integrating core with Intel FPGA 40G Ethernet MAC
Parameterization GUI allowing end user to configure IP
IP core is enabled for OpenCore Plus Support
Software drivers provided
Driver OS support
Other: AXI-Stream, or Avalon-ST
IP-XACT Metadata included
Modelsim, Questa, NCSIM
Y. Altera Board Name StratixIV GX DevKit
Industry standard compliance testing performed
If No, is it planned?
IP has undergone interoperability testing
Interoperability reports available
Design Solutions Network Members provide products and/or services that are sold or licensed by the Member and not Altera or its affiliates. Altera and its affiliates hereby disclaim any express or implied warranty of any kind including warranties of merchantability, noninfringement of intellectual property, or fitness for any particular purpose with respect to any such products and/or services.