Arria® V Device Handbook: Volume 1: Device Interfaces and Integration

ID 683213
Date 10/18/2023
Public
Document Table of Contents

8.3. Configuration Sequence

Describes the configuration sequence and each configuration stage.

Figure 187. Configuration Sequence for Arria V Devices


You can initiate reconfiguration by pulling the nCONFIG pin low to at least the minimum tCFG low-pulse width except for configuration using the partial reconfiguration operation. When this pin is pulled low, the nSTATUS and CONF_DONE pins are pulled low and all I/O pins are tied to an internal weak pull-up.