Cyclone V SoC Power Optimization

Download PDF
ID 683713
Date 2/09/2015
Public
Document Table of Contents
Document Table of Contents x
1. Cyclone V SoC Power Optimization
1. Cyclone V SoC Power Optimization x
1.1. Power Reduction 1.2. HPS Power Reduction Methods 1.3. FPGA Power Reduction Methods 1.4. Power Optimization Summary 1.5. Appendix: Power Measurement Techniques for Cyclone V SoC Dev Kit
1.2. HPS Power Reduction Methods x
1.2.1. MPU 1.2.2. Peripherals 1.2.3. HPS Power Reduction Summary
1.2.1. MPU x
1.2.1.1. HPS Method 1: Fit Code in Cache 1.2.1.2. HPS Method 2: Processor Standby Modes and Dynamic Clock Gating 1.2.1.3. HPS Method 3: CPU1 in WFI/WFE or Standby Loop 1.2.1.4. HPS Method 4: Lowering CPU Frequency
1.2.2. Peripherals x
1.2.2.1. HPS Method 5: Energy Efficient Ethernet 1.2.2.2. HPS Method 6: USB Power Management 1.2.2.3. HPS Method 7: Unused Peripherals in Reset
1.3. FPGA Power Reduction Methods x
1.3.1. FPGA Power Consumption 1.3.2. FPGA Portion Power Down 1.3.3. FPGA Power Off Step 1: Board Design (Power Rail) Choices 1.3.4. FPGA Power Off Step 2: Quiet FPGA 1.3.5. FPGA Power Off Step 3: Power Off the FPGA 1.3.6. FPGA Power Off Step 4: Wake up Event for Power on and FPGA Configuration 1.3.7. FPGA Power Off Step 5: Power On and FPGA Reconfiguration Time Considerations
1.5. Appendix: Power Measurement Techniques for Cyclone V SoC Dev Kit x
1.5.1. Power Monitoring and Measurement 1.5.2. Cyclone V SoC Development Kit Power Management ICs 1.5.3. Cyclone V SoC Development Kit Power Monitor Application 1.5.4. LTC LTpower Play Tool 1.5.5. Using the LTC2978A Linux Driver 1.5.6. Power Measurement Results on Cyclone V SoC Development Kit 1.5.7. Document Revision History
1.5.3. Cyclone V SoC Development Kit Power Monitor Application x
1.5.3.1. Starting the Application 1.5.3.2. Windows Instructions 1.5.3.3. Linux Instructions
1.5.4. LTC LTpower Play Tool x
1.5.4.1. Requirements 1.5.4.2. LTC Video Tutorial
1.5.5. Using the LTC2978A Linux Driver x
1.5.5.1. Compiling the Driver 1.5.5.2. Using the Driver
1. Cyclone V SoC Power Optimization

1.3.5. FPGA Power Off Step 3: Power Off the FPGA

Because there are no sequencing requirements for powering off the FPGA portion of the SoC device, issue the power off command that is needed to trigger the power management for your system to power off the FPGA portion.

For instance, it’s common to make use of the CONTROL0 or CONTROL1 pin on the LTC2978 device to control power on/off in a system. Routing either or both of these pins to a GPIO on the HPS side of the SoC device and then writing a 0 or 1 to the pin can power cycle the FPGA portion.

Level Two Title