F-Tile Architecture and PMA and FEC Direct PHY IP User Guide

ID 683872
Date 1/24/2024
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.14.1.2. Enabling the PRBS Generator and Verifier

The PRBS Generator and Verifier provides a method to debug and validate your PMA links.

To enable the PRBS Generator and Verifier, follow these steps:

  1. Set car_tx_clk_src_sel (0x60000[2]) to 1’b1.
  2. Set cfg_tx_bus_take_dft (0x45804[0]) to 1’b1. If using multi-lanes, set 1’b1 to all lanes.
  3. Set cfg_lane_tx_prbs_en (0x42934[0]) to 1’b1. If using multi-lanes, set 1’b1 to all lanes.
  4. Specify the PRBS generator pattern cfg_lane_tx_prbs_mode (0x42934[4:1]). If using multi-lanes, specify for all lanes.
  5. Set cfg_lane_tx_prbs_init (0x4293C[0]) to 1’b1. If using multi-lanes, set 1’b1 to all lanes.
  6. Set cfg_dft_rx_prbs_common_en (0x42930[0]) to 1’b1. If using multi-lanes, set 1’b1 to all lanes.
  7. Specify the PRBS verifier pattern, cfg_dft_rx_prbs_sel (0x42930[4:1]). If using multi-lanes, specify for all lanes.
  8. Set cfg_rx_dft_data_sel (0x42930[6:5]) to 2’b00. If using multi-lanes, set 2’b00 to all lanes.
  9. Set cfg_ber_symb_cnt_limit_lsb (0x428EC[31:0]). If using multi-lanes, set for all lanes.
  10. Set cfg_ber_symb_cnt_limit_msb (0x428F0[31:0]). If using multi-lanes, set for all lanes.
  11. Set cfg_dft_ber_count_en (0x428DC[0]) to 1’b1. If using multi-lanes, set 1’b1 to all lanes.
  12. Set cfg_dft_ber_count_mode (0x428DC[2:1]) to 2’b10. If using multi-lanes, set 2’b10 to all lanes.