HDMI Intel® Stratix® 10 FPGA IP Design Example User Guide

ID 683701
Date 1/26/2024
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

1.2. Generating the Design

Use the HDMI Intel® FPGA IP parameter editor in the Intel® Quartus® Prime software to generate the design examples.

Starting with the Nios® II EDS in the Intel® Quartus® Prime Pro Edition software version 19.2 and Intel® Quartus® Prime Standard Edition software version 19.1, Intel has removed the Cygwin component in the Windows* version of Nios II EDS, replacing it with Windows* Subsytem for Linux (WSL). If you are a Windows* user, you need to install WSL prior to generating your design example.

Figure 3. Generating the Design Flow
  1. Create a project targeting Intel® Stratix® 10 device family and select the desired device.
  2. In the IP Catalog, locate and double-click HDMI Intel® FPGA IP . The New IP Variant or New IP Variation window appears.
  3. Specify a top-level name for your custom IP variation. The parameter editor saves the IP variation settings in a file named <your_ip>.ip.
  4. Click OK. The parameter editor appears.
  5. On the IP tab, configure the desired parameters for both TX and RX.
  6. Turn on the Support FRL parameter to generate the HDMI 2.1 design example in FRL mode. Turn it off to generate the HDMI 2.0 design example without FRL.
  7. On the Design Example tab, select Stratix 10 HDMI RX-TX Retransmit.
  8. Select Simulation to generate the testbench, and select Synthesis to generate the hardware design example.
    You must select at least one of these options to generate the design example files. If you select both, the generation time is longer.
  9. For Generate File Format, select Verilog or VHDL.
  10. For Select Board, select the relevant development kit. You may change the target device using the Change Target Device parameter if your board revision does not match the grade of the default targeted device. For Stratix 10 GX FPGA L-tile Development Kit, the default device is 1SG280LU2F50E2VG, and for Stratix 10 GX FPGA H-tile Development Kit, the default device is 1SG280HU2F50E2VG.
  11. Click Generate Example Design.