HDMI Intel® Stratix® 10 FPGA IP Design Example User Guide

ID 683701
Date 1/26/2024
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

2.8. Running the Design in Different FRL Rates

You may run your design in different FRL rates, other than the external sink's default FRL rate.

To run the design in different FRL rates:

  1. Toggle the on-board user_dipsw0 switch to ON position.
  2. Open the Nios® II command shell, then type nios2-terminal.
  3. Key in the following commands and press Enter to execute.
Command Description
h Show the help menu.
r0 Update the RX maximum FRL capability to FRL rate 0 (TMDS only).
r1 Update the RX maximum FRL capability to FRL rate 1 (3 Gbps).
r2 Update the RX maximum FRL capability to FRL rate 2 (6 Gbps, 3 lanes).
r3 Update the RX maximum FRL capability to FRL rate 3 (6 Gbps, 4 lanes).
r4 Update the RX maximum FRL capability to FRL rate 4 (8 Gbps).
r5 Update the RX maximum FRL capability to FRL rate 5 (10 Gbps).
r6 Update the RX maximum FRL capability to FRL rate 6 (12 Gbps).
t1 TX configures link rate to FRL rate 1 (3 Gbps).
t2 TX configures link rate to FRL rate 2 (6 Gbps, 3 lanes).
t3 TX configures link rate to FRL rate 3 (6 Gbps, 4 lanes).
t4 TX configures link rate to FRL rate 4 (8 Gbps).
t5 TX configures link rate to FRL rate 5 (10 Gbps).
t6 TX configures link rate to FRL rate 6 (12 Gbps).