Intel® Stratix® 10 Clocking and PLL User Guide

ID 683195
Date 9/08/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.3.3.1.1. Recalibration Using .mif

Recalibration using .mif only allows you to recalibrate the I/O PLL but not to reconfigure the I/O PLL. In the IOPLL Reconfig IP core, enable Recalibration Mode. When the recalibration is selected, a recalibration.mif file is generated automatically for the recalibration operation.

To perform I/O PLL recalibration using .mif, follow these steps:

  1. Set mgmt_address[9:8] = 2’b00 to choose the .mif mode and set mgmt_writedata[4:0] = 2'b00.
  2. To start the recalibration using .mif on the I/O PLL, assert the mgmt_write signal for one mgmt_clk cycle. mgmt_waitrequest is asserted by the IOPLL Reconfig IP core while recalibration is in progress.
  3. After the recalibration is complete, the mgmt_waitrequest signal is deasserted.